- Capacity
- 2,048 Wh
- AC output
- 2,400 W
- Surge
- Not published
- Solar input
- 500 W
- Weight
- 48.5 lb
As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
BLUETTI · Large (1,500 to 3,499 Wh)
BLUETTI Elite 200 V2
A large unit, 2,074 Wh, 2,600 W, 53.4 lb, $899 at BLUETTI, checked Nov 9, 2026 ($0.43 per Wh). By our sizing it holds a night of CPAP, two nights of camping, a day in an RV, a working day in a van and a laptop and two phones, but not a day of home backup.
From the maker's published figures and our own calculations; we have not tested it ourselves.
2,074 Wh
2,074 Wh × 0.85 ÷ device watts. An estimate, not a measured test. Startup and connections need checking.
Should you buy it?
Buy it for: a night of CPAP (a CPAP with its humidifier for one 8-hour night); two nights of camping (camp lights, phones, a laptop and a fan for two nights); a day in an RV (a day of RV lights, TV, phones and a laptop); a working day in a van (a working day of laptop, Starlink, lights and a fan); a laptop and two phones (a laptop for six hours and two phone charges).
Not for: a day of home backup (too little capacity: needs 2,323 Wh and 1,351 W at startup).
Choose it for a 9.9 lb lighter carry: about the same price as the Pecron F3000LFP.
Choose the Pecron F3000LFP instead if you want the most battery for the money: $0.29 per Wh against $0.43, 9.9 lb heavier.
Not published The maker publishes no surge figure, so motor and compressor starts rest on its continuous rating.
About 1,763 Wh reaches the AC outlets after the 0.85 loss allowance (an estimate, not a measurement). At $0.43 per watt-hour, compare its cost with the charging speed and carry weight you need. It stores 38.8 Wh per pound. We list 41 other models in its size class; the four nearest in capacity are compared below.
What it runs, and for how long
Hours = capacity × 0.85 ÷ device watts, with the draws from the device table.
| Device | Draw W | Hours | Output and surge cover it? |
|---|---|---|---|
| CPAP machine (no heated humidifier) | 45 | 39.2 | yes |
| CPAP machine (with heated humidifier) | 53 | 33.3 | yes |
| Refrigerator (full-size, ENERGY STAR, ~18 cu ft top freezer) (average draw, compressor cycling) | 41 | 42.7 | yes |
| Laptop (MacBook Air, charging) (charger rating, continuous) | 40 | 44.1 | yes |
| Wi-Fi router | 24 | 73.4 | yes |
| Starlink Mini (router built in) | 33 | 54.2 | yes |
| TV, 50-inch LED / Crystal UHD | 89 | 19.8 | yes |
| Camp LED light set (4 chainable lights) | 6 | 279.8 | yes |
"Yes" means its continuous output covers the draw and its surge rating covers the startup figure we use, by arithmetic on ratings, not a test. Startup figures: the CPAP with its humidifier, 104 W at startup, from ResMed's peak figure; the refrigerator, 1,300 W startup allowance, from a larger 27 cu ft Whirlpool's tech sheet. Your own appliance's label or manual has its own.
Sockets and size
- Four AC outlets, 2,600 W in total
- Two USB-C ports, up to 100 W from one port
- Two USB-A ports
- One 12 V outlet
How many of each socket and their limits, from the maker's spec sheet; it does not say where each one sits on the unit. It weighs 53.4 lb.
At a glance
How it compares with the other 41 large models, on the makers' figures. We don't boil it down to one score; see how we pick.
| What it can power | Covers a night of CPAP, two nights of camping, a day in an RV, a working day in a van, and a laptop and two phones. Output and surge cover 17 of the 18 devices in our list, on the startup figures we use |
|---|---|
| Price per Wh | $0.43 per Wh, 19th lowest of 42 large units |
| Portability | 53.4 lb, 25th lightest of 42 large units |
| Recharge speed | 1,000 W of solar input: at least 2.1 hours of full sun at that limit to refill (an ideal minimum, not clock time); 1,800 W from the wall |
| Chemistry and cycle life | LiFePO4, rated 6,000 cycles to 80% |
| Expandability | No extra batteries; 15 ms UPS switchover |
Full spec sheet
| Capacity | 2,074 Wh |
|---|---|
| Chemistry | LiFePO4 |
| Rated cycle life | 6,000 to 80% |
| Expandable | no |
| Continuous AC output | 2,600 W |
|---|---|
| Surge (peak) output | – |
| AC outlets | 4 |
| USB-C ports / highest output | 2 / 100 W |
| USB-A ports | 2 |
| 12 V outputs | 1 |
| Wireless charging pad | no |
| UPS / EPS switchover | 15 ms |
| Max AC input | 1,800 W |
|---|---|
| Wall recharge time | 1.4 h |
| Max solar input | 1,000 W |
| Stated solar recharge time | – |
| App control | yes |
| Weight | 53.4 lb (24.2 kg) |
|---|---|
| Dimensions | 13.78 x 9.84 x 12.74 in (350 x 250 x 323.6 mm) |
| Wh per lb | 38.8 |
| Release year | – |
| Warranty | 5 years |
| List price | $899, checked Oct 7, 2026 |
|---|---|
| Store price | $899 at BLUETTI, checked Nov 9, 2026 |
| Price per Wh | $0.43 |
Before using the battery's cycle rating to judge value, read what LiFePO4 versus NMC means for lifespan and weight.
What the output figures mean for your devices: running and surge watts, and what a 15 ms switchover means if you use it as a UPS.
To charge it from a running vehicle: BLUETTI Charger 1 (560 W).
Which maker panels its solar input takes, how to wire them and the hours of sun to refill it: the Elite 200 V2 solar setup.
Living with the Elite 200 V2: what BLUETTI says
- If the AC outlets switch off by themselves: AC-ECO and DC-ECO are on from the box, so the outputs switch off after a while with a low load or none. BLUETTI says to turn ECO off for devices under 60 W and for lights and refrigerators: the AC power button switches both, the app each one.
- Its standby draw: BLUETTI gives its own consumption as about 10 W, about 240 Wh over a day. Compare every station's standby figure.
- In the cold: BLUETTI gives 32 to 104 °F (0 to 40 °C) for charging and −4 to 104 °F (−20 to 40 °C) for running it, so below freezing it can still power your devices but will not take a charge until it is warmer.
- Storing it: 14 to 104 °F (−10 to 40 °C), and under 95 °F (35 °C) for more than a month. Unused for more than 3 months, store it switched off at 40 to 60%, and discharge and recharge it every 3 months (another page of the manual says every 6).
- The warranty: 5 years.
The full manual: BLUETTI Elite 200 V2 user manual (PDF, from BLUETTI).
BLUETTI's own words
- "AC-ECO and DC-ECO modes are enabled by default. The Elite 200 V2 shuts off the AC or DC output after a period of low or no load."
- "Press the AC power button to turn on/off AC-ECO and DC-ECO modes together, and use the BLUETTI app to control them separately."
- "Disable the ECO mode when connecting small devices under 60W or critical appliances such as lights and refrigerators."
- "The Elite 200 V2 self-consumption is about 10W."
- "Charging Temperature: 0°C to 40°C (32°F to 104°F)"
- "Discharging Temperature: -20°C to 40°C (-4°F to 104°F)"
- "Safe storage temperature: -10°C to 40°C (14°F to 104°F). For storage over a month, keep it below 35°C (95°F)."
- "Fully cycle every 6 months to maintain battery health."
- "5. If not used for more than 3 months, charge the unit to 40%-60% SoC and store it with the power off. For optimum battery life, discharge and charge the unit every 3 months."
- "Extended Warranty: Enjoy a 5-year warranty and dedicated customer support that's always ready to help."
From the BLUETTI Elite 200 V2 User Manual and the BLUETTI Elite 200 V2 product page.
Alternatives at this size
Listed smallest to largest by capacity; this unit is among them.
Select up to three models to compare.
- Capacity
- 2,048 Wh
- AC output
- 2,800 W
- Surge
- Not published
- Solar input
- 1,200 W
- Weight
- 47.6 lb
- Capacity
- 2,074 Wh
- AC output
- 2,600 W
- Surge
- Not published
- Solar input
- 1,000 W
- Weight
- 53.4 lb
- Capacity
- 2,074 Wh
- AC output
- 2,700 W
- Surge
- Not published
- Solar input
- 1,000 W
- Weight
- 53.4 lb
- Capacity
- 2,096 Wh
- AC output
- 2,000 W
- Surge
- 4,000 W
- Solar input
- 600 W
- Weight
- 46.5 lb
No models match these filters.
| Model | Wh | Output W (surge) | lb | Solar input W | Chemistry | Cycles | Price at maker $ | Price per Wh | Store |
|---|---|---|---|---|---|---|---|---|---|
| Aferiy P210 | 2,048 | 2,400 W | 48.5 | 500 | LiFePO4 | 4,000 to 85% | $659sold out when checked Nov 17, 2026 | $0.32 | Check price on AmazonAmazon's price may differ See it at Aferiy |
| Aferiy P280 | 2,048 | 2,800 W | 47.6 | 1,200 | LiFePO4 | 4,000 to 85% | $739checked Nov 17, 2026 | $0.36 | See it at Aferiy |
| BLUETTI Elite 200 V2 | 2,074 | 2,600 W | 53.4 | 1,000 | LiFePO4 | 6,000 to 80% | $899checked Nov 9, 2026 | $0.43 | See it at BLUETTI Check price on AmazonAmazon's price may differ |
| BLUETTI Premium 200 V2 | 2,074 | 2,700 W | 53.4 | 1,000 | LiFePO4 | – | $1,549checked Nov 17, 2026 | $0.75 | See it at BLUETTI |
| Zendure SuperBase Pro 2000 | 2,096 | 2,000 W (4,000 surge) | 46.5 | 600+ 1,800 W at 60 to 160 V | NMC | – | $1,999sold out when checked Nov 17, 2026 | $0.95 | See it at Zendure Check price on AmazonAmazon's price may differ |
Side by side, figure by figure: Elite 200 V2 vs BLUETTI AC200L, Elite 200 V2 vs BLUETTI Apex 300, Elite 200 V2 vs Anker SOLIX C2000 Gen 2, Elite 200 V2 vs BLUETTI Elite 100 V2 and Elite 200 V2 vs BLUETTI Premium 200 V2. Every comparison.
See it at BLUETTI Check price on AmazonAmazon's price may differ Every BLUETTI model we cover Does it hold enough for your devices?
Amazon offers a free 30-day Prime trial, with free delivery on eligible items. Try Prime free (a paid link, like the Amazon buttons).
Before connecting panels, compare your array's cold-morning open-circuit voltage and short-circuit current with this model's solar-input limits in its manual.
Sources
- Specs: BLUETTI product page
- Specs (p. 22): BLUETTI user manual (PDF)
- Warranty: BLUETTI warranty page, checked Sep 6, 2026
- Price: BLUETTI product page, checked Nov 9, 2026
- How the figures and picks are made