May we count your visit with Google Analytics? It uses cookies and sends visit data to Google. You can change this any time under Cookie choices. Privacy
Two 1 kWh LiFePO4 stations with 1,800 W of output: Anker SOLIX's first C1000 (1,056 Wh, 28.44 lb, 600 W of solar) against BLUETTI's Elite 100 V2 (1,024 Wh, 25 lb, 1,000 W of solar). The Elite 100 V2 is the cheaper energy, 14% less per watt-hour at the makers' prices, is 3.4 lb lighter and takes 1,000 W of solar against 600 W. The C1000 refills from the wall in 58 minutes against 1 hour 10 minutes: buy it for that once Anker SOLIX has it in stock, and the Elite 100 V2 for the money.
Compare the differences that matter for your devices; Anker SOLIX C1000 leads on 3, BLUETTI Elite 100 V2 on 6, and the rest are equal or not comparable.
Cycle counts are highlighted only when both makers rate them to the same remaining capacity. A full recharge is not ranked against a charge to 80%. Missing figures never count as an advantage. These are manufacturer ratings; matching endpoints do not prove identical test conditions.
Rated cycles: C1000, 3,000 to 80%; Elite 100 V2, 4,000 to 80%.
As the maker states it; a dash where not published
Estimated AC energy = rated Wh × 0.85. Runtime = estimated AC energy ÷ load W, with no reserve. Capacity and weight differences use the displayed figures; price per Wh uses each model's own price and the day it was checked. The device draws are in the watt-hour calculator.
Capacity: Elite 100 V2 minus C1000 = -32 Wh (-3% of the C1000 figure).
Carry weight: Elite 100 V2 minus C1000 = -3.44 lb (-12.1% of the C1000 figure).
Price per Wh: Elite 100 V2 minus C1000 = -0.08 USD/Wh (-14.2% of the C1000 figure).
Will it run your gear?
Check whether each unit has enough battery and output for the devices you want to run.
Can it run this?
Use
Needs
C1000
Elite 100 V2
a day of home backup (a full-size refrigerator, a router, phones and lights for a day)
2,323 Wh, 161 W running, 1,351 W startup
no: too little capacity
no: too little capacity
a night of CPAP (a CPAP with its humidifier for one 8-hour night)
a laptop and two phones (a laptop for six hours and two phone charges)
396 Wh, 60 W running, 60 W startup
yes
yes
Runtime by device
Hours = capacity × 0.85 ÷ device watts, with the draws from the device table; "Start" says whether the output and surge ratings cover the startup figure we use for each device (the refrigerator, 1,300 W startup allowance, from a larger 27 cu ft Whirlpool's tech sheet), so a "yes" there means likely, not certain, to start yours.
Hours on a full charge
Device
Draw W
C1000 h
Start
Elite 100 V2 h
Start
CPAP machine (with heated humidifier)
53
16.9
yes
16.4
yes
Refrigerator (full-size, ENERGY STAR, ~18 cu ft top freezer) (average draw)
41
21.7
yes
21.1
yes
Laptop (MacBook Air, charging)
40
22.4
yes
21.8
yes
Wi-Fi router
24
37.4
yes
36.3
yes
Starlink Mini (router built in)
33
27.6
yes
26.8
yes
TV, 50-inch LED / Crystal UHD
89
10.1
yes
9.8
yes
Space heater, 1500 W
1,500
0.6
yes
0.6
yes
Buy the C1000 if…
you want the extra capacity (1,056 Wh against 1,024 Wh)
Top and front, to scale: 14.8 × 8.07 × 10.5 in. Ruler: 12 in.
Buy the Elite 100 V2 if…
you want the most stored energy per dollar ($0.49 against $0.57 per Wh)
the $100.99 difference matters more than the specs
you carry it more than you run it (25 lb against 28.4 lb)
you need a higher solar input ceiling (1,000 W against 600 W); actual recharge depends on the panels
it will sit between the wall and a refrigerator or router (maker-stated 10 ms switchover; 20 ms for the other)
you want the higher stated cycle count at the same 80% remaining capacity (4,000 against 3,000); test conditions can still differ
Top and front, to scale: 12.6 × 8.5 × 9.8 in. Ruler: 12 in.
Which is better for power outages, the C1000 or the Elite 100 V2?
Anker SOLIX C1000 states a 20 ms switchover, so it can sit between the wall and a fridge or router and take over when the power cuts, once the device is in an outlet the manual gives the backup to and any AC timeout is off (for a CPAP or a computer, check that device rides through the switch); BLUETTI Elite 100 V2 states 10 ms. Anker SOLIX C1000 holds more (1,056 against 1,024). Check your appliance's startup watts against the surge figures in the table.
Which is cheaper per watt-hour?
Elite 100 V2 at $0.49 per Wh against $0.57. This compares purchase price with rated capacity, not lifetime delivered energy.
Can either run a window air conditioner?
Only if the air conditioner's running watts stay under the AC output (1,800 W on the C1000, 1,800 W on the Elite 100 V2) and its start fits the surge figures in the table: read both on the air conditioner's label or in its manual, and test it before you rely on it. For the hours, multiply the rated Wh by 0.85 for inverter losses and divide by the running watts. A 5,000 BTU window unit such as GE's AHEC05AC draws 455 W while the compressor runs, and we allow 1,800 W for its start: both units' surge figures cover that start. On a full charge it would run about 2 hours on the C1000 and about 1.9 hours on the Elite 100 V2, with the compressor running without a break; a thermostat that switches it off in a cool room stretches that.